How to Manually Regenerate (Recharge)

There are times when your supply of treated water may not last until the next regeneration. This could be because of household guests for an extended time or an unusually large consumption of water. If this is the case, you can manually regenerate (recharge) your water treatment system, assuring an adequate supply of treated water. Remember that your hot water heater may contain hard water during these times; until you use the hard water (which should be a very short time), you will not have totally treated water.

Hostess II
1. Remove Control Cover - lift up.
2. To start regeneration cycle manually, push Cycle Actuator Lever to the right.
3. Unit will automatically go through a FULL regeneration cycle and return to normal service position.
4. Replace cover.

Elan, Hostess, and Microclear
1. Remove Control Cover - loosen cover screws. Pull cover forward.
2. Turn Manual Regeneration Knob clockwise until Time of Day Indicator points to the next hourly number, i.e. 2p to 3p.
3. This slight movement of knob engages Program Wheel, starts regeneration cycle, and will return unit to normal service position when cycle is completed.
4. Replace cover.

Sensial and Sensial Meter
1. Remove Control Cover - lift up.
2. Turn Manual Regeneration Knob clockwise from "SERVICE" to "REGEN."
3. This movement of knob engages Program Wheel, starts regeneration cycle, and will return unit to normal service position when cycle is completed.
4. Replace cover and plug.

Pulse
1. Remove Control Cover - loosen cover screws. Pull cover forward.
2. Turn Manual Regeneration Knob clockwise until the first click is heard. This slight movement of knob engages Program Wheel and starts regeneration.
3. Replace cover.

Elan E.M. and Sensial E.M.
1. Press and Release the Extra Cycle Button. The service light will begin to flash immediately and a regeneration will occur at the preset regeneration time (i.e. 2:00 a.m.).
2. Press and hold the Extra Cycle Button for five seconds. The service light will turn "on" and the unit will go into an immediate regeneration.